Silvercrest SWV 733 A2 Operating Instructions And Safety Instructions page 81

The configuration menu of the dual-band Wi-Fi range extender is not shown.
 The address http://repeater.setup was entered into the address line of the Internet browser
incorrectly; check and correct the entry.
 The configuration of the dual-band Wi-Fi range extender is incorrect. Reset the dual-band Wi-Fi range
extender to its original condition. To do so, press the Reset button (5) for approximately 3 seconds
with a sharp object and then release it again. The LEDs then briefly go out and this will reboot the
dual-band Wi-Fi range extender. The dual-band Wi-Fi range extender requires a certain amount of
time (boot time) before it is ready to use. Wait for approximately 30 seconds before using the dual-
band Wi-Fi range extender.
 Please check whether the network connection is correctly established between the end device and the
dual-band Wi-Fi range extender. Note that the network connection is cancelled after you configure
the menu. Your system requires a short period to restore the network connection.
 Please reboot your computer/notebook. Then re-establish the connection to the dual-band Wi-Fi range
extender.
SilverCrest SWV 733 A2
English - 79