Booting V-Class Systems - HP -UX 11i Installation And Update Manual

V2200 system
boot console
Booting HP 9000 Systems

Booting V-Class Systems

Booting V-Class Systems
To boot the system from the Install media, follow the initial instructions
on powering up the system and any external drive, as explained in
"Halting the Boot Process" in this appendix.
Portions of a typical V-Class boot display are shown below. To stop the
system boot process and select the device with the install media, press any
key within ten seconds after you see "System is HP9000 V2000 series":
OBP reboot
SPP2000, POST version 3.1.4.0, compiled 1997/06/27 10:38:45
LAB #0001
...
Booting OBP.
...
System is HP9000 V2000 series
Autoboot and Autosearch flags are both OFF or we are in HP core
mode.
Processor is entering manual boot mode. ...
If the system is set to perform auto-boot, you will see the following:
Processor is starting the autoboot process.
To discontinue, press any key within 10 seconds. ...
Press any key at this point. You will see the following boot menu (capital
letters indicate minimum-required command):
Command
AUto [BOot|SEArch ON|OFF]
flag
BOot [PRI|ALT|<path> <args>]
BootTimer [time]
CLEARPIM
CPUconfig [<proc>] [ON|OFF]
DEfault
DIsplay
94
Description
Display or set the specified
Boot from a specified path
Display or set boot delay time
Clear PIM storage
Configure/Deconfigure Processor
Set the sytem to defined values
Display this menu
Appendix A