Outdoor Station Settings - ABB Welcome IP IPTouch 7 Series Product Manual

8.3.3

Outdoor station settings

These settings are only supported by the pushbutton outdoor station.
Outdoor station enters engineering mode
Power on the outdoor station, wait until all 3 LED indicators go out.
■
■ Press the first button on the outdoor station and hold for 10 s until all 3 LED indicators flash.
Tip
The outdoor station will exit engineering mode after 5 minutes.
Indoor station goes to the settings page
On the "Engineering settings" screen, click "Outdoor station settings" to access the
corresponding screen.
Product manual 2TMD041900D0001
Commissioning
│70