LG MULTI V HYDRO KIT ARNH963K2A4 Installation Manual page 73

4. Seal all gaps or holes behind the installation plate before mounting. If mounting
the controller over a handy box, seal the holes in the handy box using spray
foam or similar insulation material approved by all applicable codes.
5. Attach the top of the controller to the top of the installation plate. Verify that the
controller is level and secure.
6. Plug the male connection on the controller into the female end of the communi-
cations cable.
7. Connect the Hydro Kit controller cable to terminal CN-REMO on the Hydro Kit
PCB.
8. Guide the bottom of the controller to the bottom of the installation plate. Gently
push on the controller along the bottom edge until it snaps onto the plate. Verify
that it is properly seated with no gaps between the controller and the installation
plate.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
CONTROLLER INSTALLATION
Figure 78: Location of the Controller Installation Plate
Screws.
Wall Wall
Wall Wall
73