Pipe Connection; Correct Disposal Of This Product - Philips AWH1110 User Manual

Please use our company's tted accessories to mount this electric water
heater.
Before determining the bolt hole's position, you should ensure that the
heater is more than 200mm from the ground or ceiling board. This will
leave space for maintenance when necessary.
Assembling method: after selecting the proper xing positions, use the
in ating bolt to secure the hanging board rmly, then hook the electric
water heater. (Diagram 4)

6 Pipe connection

All piping parts are BSP / '' Wind some white tape at the thread sector
1
2
of the inlet pipe. (marked blue)
Fix the safety valve to the inlet pipe and then connect it to the cold water
pipe of the mains.
Install a water drainpipe to the safety valve to drain away water discharge.
(drain pipe joint outlet-diagram 5)
Install the drainpipe in a continuously downward direction and in a frost
free environment.
Connect the hot water pipe (marked red) to the outlet pipe.
Do not over-tighten the safety valve and all pipes joint as it may cause
damage to the joints.
Make sure all pipes are clean before installing the taps and showers.

7 Correct disposal of this product

This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning using of the appliance in a safe way and understand
04
Diagram 4
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly quali ed persons in order to avoid a hazard.
Water may drip from the discharge pipe of the pressure-relief device, so
please keep the pipe open to atmosphere.
The pressure-relief device should be operated regularly to remove lime
deposits and to verify that it is not blocked.
A discharge pipe connected to the pressure-relief device should be
installed downward and in a frost-free environment.
Appliance must be xed with device compliance IEC 61770.
Please always mix hot water with cold water before showering or washing,
to avoid superhot water causing severe burns.
The water discharged from the water heater cannot be used for drinking.
The heater cannot be installed near strong electromagnetic elds.
The water heater is suitable for domestic use. If for commercial use, service
life may be shortened.
Do not spray any combustible materials such as insecticides or perfumes
around the product.
This symbol on the product, or in its packaging, indicates that this product
may not be treated as household waste. Instead, it should be taken to the
appropriate waste collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by the inappropriate waste
handling of this product. For more detailed information about
the recycling of this product, please contact your local council,
your household waste disposal service, or the shop where you
purchased the product.
05