Huawei AISU User Manual page 32

AISU
User Manual
Step 3 Press F9 or click Exec.
If Operation succeeded is displayed in the command export area, the AISU properties are
modified successfully. If the AISU properties fail to be modified, identify causes and modify
the AISU properties again.
Step 4 Wait for 6 hours and query antenna engineering parameters after the test data is stable.
----End
Querying the AISU Properties
You can run the DSP RAEDEVICEDATA command to query the AISU engineering
parameters, including the antenna azimuth, mechanical tilt, latitude, longitude, and altitude.
Procedure
Step 1 In the parameter input area, enter DSP RAEDEVICEDATA in Command (F5), and then
click Assist or press Enter.
Step 2 In the parameter input area, specify related parameters.
The parameter values in the following figure are for reference only.
Step 3 Press F9 or click Exec.
If Operation succeeded is displayed in the command export area, the AISU properties are
queried successfully. If the AISU properties fail to be queried, identify causes and query the
AISU properties again.
Issue 02 (2017-06-12)
 Antenna Bearing, Installed Mechanical Tilt, Altitude, Latitude With Degree Format, and
Longitude With Degree Format are read-only.
 Antenna Model Number, Serial No., Band, Beamwidth, Gain, Installation Date, and Base
Station ID can be modified as required.

The value of Sector ID is set to the sector ID queried in section "Querying Antenna Sector Status."
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Guide
27