Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Display a List of Transcoder Cards Installed in the Chassis
1. Access the HCS6300 Main Menu as described on page 31.
2. At the [Main] Command > prompt, type list and press Enter.
The display identifies the type of transcoder cards installed and their serial numbers, for
example:
Available cards:
Card
1: [HCS7700] [001-12080022]
Card
2: [HCS7700] [001-12080023]
Card
3: [-]
Card
4: [HCS7700] [001-12080024]
Card
5: [HCS7700] [001-12080025]
Card
6: [-]
Card
7: [-]
Card
8: [HCS7700] [001-12080026]
Card
9: [HCS7700] [001-12080027]
Card 10: [-]
Card 11: [HCS7700] [001-12080028]
Card 12: [HCS7700] [001-12080029]
Access Individual Transcoder Menus
See "Transcoder Menu Commands" on pages 40 to 43 for detailed information on transcoder
configuration options.
Perform an External Card Reset
1. Access the HCS6300 Main Menu as described on page 31.
2. At the [Main] Command > prompt, type xrst and press Enter.
3. At the Enter card number (1-12, 'ctr', or 'all') > prompt, either:
• Type the slot number of the card and press Enter to reset a single transcoder card.
• Type all and press Enter to reset each of the transcoder cards (including any transcoders
in Slots 3, 6, and/or 10).
• Type ctr and press Enter to reset the HCS6300.
If you opt to reset one or more of the transcoder cards, the system will display confirmation
before resetting the selected card(s), for example:
Resetting card 5:
If you opt to reset the HCS6300, the system will initiate the reset immediately without further
confirmation.
206-4122
33
Advertisement
Table of Contents
