Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Satellite Receiver Menu Commands
The following subsections describe how to access and use the Satellite Receiver Menu
commands.
Access the Satellite Receiver Menu
1. Access the card menu for the selected transcoder (see "Access the Transcoder Menu" on
page 40).
2. At the [Card (#)] Command > prompt, type stb and press Enter.
3. At the [Satellite (#)] Command > prompt, either:
• Press Enter to display the Satellite Receiver Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the Command > prompt to display the Satellite
Receiver Menu.
Example: Satellite Receiver Menu
-----------------------
Satellite Receiver Menu
-----------------------
getch
Read Current STB Channel
setch
Set STB Channel
lksts
Read Satellite Lock Status
sglvl
Read Satellite Signal Strength
actsts
Read STB Activation Status
cnum
Read Access Card Number
bnum
Read STB Serial Number
osdon
Set Satellite OSD On
osdoff
Set Satellite OSD Off
on
Turn STB On
off
Turn STB Off (Standby)
stbrst
Reset Satellite STB
atune
Read Auto Tune Parameters
atset
Set Auto Tune Parameters
ret
Return to Card Menu
[Satellite (#)] Command >
44
where:
# is the chassis card/slot
number you selected for
configuration purposes.
206-4122
Advertisement
Table of Contents
