Software Installation; Installation Of Softune Workbench; Installation Of Communication Interface Drivers; Rs 232 Communication - Fujitsu MB904 Series Application Note

Table of Contents

3 Software Installation

To work with the emulator MB2147-05 Softune Workbench V30L28 (ProPack300013) or

higher must be used. Included in the shipping of the MB2147-05 is a CD-ROM containing

the corresponding software package. To install the

corresponding installation set-up and follow the installation instructions.

If the communication to the ICE is going via RS232 no special drivers have to be installed.

Just connect the RS232 interface of the ICE to the RS232 interface of the PC using the

serial cable supplied with the ICE.

If the communication to the ICE is going via the USB interface a special USB driver must be

installed. To install the USB drivers perform the following steps:

As soon as the ICE is connected to the PC the new hardware will be recognized

automatically and the standard windows dialog will appear to install the corresponding

drivers. The USB drivers can be found in the Softune/Drivers directory on the CD-ROM

delivered with the compact ICE or will be available separately as a zip file in case the

Microcontroller CD-ROM V3.4 (available Q1/2003) is used. Use this USB driver if you are

ask for special USB drivers to be installed for the ICE.

MCU-AN-390077-E-V11

Chapter 3 Software Installation

Switch on the PC

switch on the ICE

connect the ICE to the PC

Softune Workbench start the

- 14 -

Table of Contents