Display - Siemens SENTRON 7KT1681 Manual

Description
3.3 7KT PAC1600 multimeter
The
minimum values for the selected measurement). The currently displayed subpage is
displayed on the bottom right by one of the following symbols:
● IN: Instantaneous value
Current instantaneous value of measurement, which is displayed as a default on every
change of page.
● HI: Highest peak
Highest value measured by the energy meter for the selected measurement Peak values
are also stored and retained when the power supply is switched off. A special command
exists for resetting the stored peak values. You can find more information on this in
chapter Command menu (Page 36).
● LO: Lowest value
Measured by the energy meter from the time when voltage was present. You can reset
this value with the same command that is used for HI values. You can find more
information on this in chapter Command menu (Page 36).
● AV: Average value
Time-integrated (average) value of measurement. You can find more information on
parameter "M04 Integration" in chapter Parameter tables (Page 28).
● MD: Max. demand values
This is stored in non-volatile memory and can be reset using a special command.
Programming functions
● You can select the page and the subpage to which the display automatically returns after
a defined time without having to press a key.
● You can program the multimeter such that the display always shows the most recently
selected page.
● You can find information on setting up these functions under parameter P02 Utility in
chapter Parameter setting (setup) from the front panel (Page 23).
3.3.3

Display

Note
The lines printed in bold in the table may not be displayed if the function or parameter which
controls them is not activated.
Example:
If no alarm is programmed, the corresponding page is not visible.
Pages and subpages are selected with the following keys:
● Select pages with
● Select subpages with
18
key permits access to subpages on every page (e.g. to display the maximum and
/
7KT multimeter
Manual, 08/2018, 2514284149-01