Siemens SENTRON 7KT1681 Manual page 26

Description
3.4 Parameterization
5. Select the submenu and the serial parameter number as appropriate.
Use the keys as follows:
–
–
–
–
6. After setting the required parameter number, use the
parameter appears in the alphanumeric display.
Use the keys as follows:
– Press
– Press
– Press
– Press
The required value is selected.
7. Press
The display returns to the previous menu level (parameter selection).
8. Press
Note
Alternatively, you can hold down
changes and exit parameter settings directly.
The device is rebooted.
Note
If you do not press any key for a period of 2 minutes, the system exits the setup menu and
returns to the standard display without saving the parameters.
24
: Back
: Decrease
: Increase
: Next
or : To change the parameter within the permissible range.
and simultaneously: To set the minimum possible value.
and simultaneously: To set the maximum possible value.
and simultaneously: To restore the factory default value.
to save the parameter.
repeatedly to leave and save the parameters.
key to switch to edit mode. The
for 3 seconds during programming to save the
7KT multimeter
Manual, 08/2018, 2514284149-01