Command Menu - Siemens SENTRON 7KT1681 Manual

Description
3.4 Parameterization
3.4.7

Command menu

The command menu allows you to perform occasional operations (e.g. to reset measured
variables and counters).
After entering the password for the extended level, you can also use the command menu to
perform automatic operations which are useful for the configuration of the device.
The following functions are available in the command menu, separated according to the
required access level.
Code Command
C.01 RESET HI-LO
C.02 RESET MAX DEMAND
C.03 RESET PAR.ENERGY
C.04 RESET PAR.HOURS
C.07 RESET ALARMS
C.08 RESET LIMITS
C.11 RESET TOT.ENERGY
(Not with MID devices)
C.12 RESET TOT.HOURS
C.13 SETUP TO DEFAULT
C.14 BACKUP SETUP
C.15 RESTORE SETUP
C.16 WIRING TEST
1. Select the required command.
2. Press
3. Press
4. Press
5. Press
36
Access level
User lev-
el/administrator
Administrator
to execute the command.
again to execute the command.
to cancel execution of the command.
to exit the command menu.
Description
Resets the HI and LO values of all measurements.
Resets the maximum demand values for all meas-
urements.
Resets the partial energy meters.
Resets the partial hour counters.
Resets alarms.
Resets limit values
Resets the total and partial energy meters.
Resets the total hour counter.
Restores all the factory settings for the device.
Saves a backup copy of all setup parameters.
Loads the settings from the backup copy.
Runs the test to check whether the device is connect-
ed correctly.
You can find more information in chapter Wiring test
(Page 37).
Manual, 08/2018, 2514284149-01
7KT multimeter