Commissioning With Rmz Operator Units; Start Commissioning, Plant Mode "Off - Siemens RXB Series Basic Documentation

Introduction
Note
Access levels
Commissioning,
password level
Home page
Action
Path
Main menu
Action
26 / 88
Siemens
Building Technologies
3.2

Commissioning with RMZ operator units

The Synco 700 type RM controllers can be commissioned with operator units
RMZ790 and RMZ791 (but not RMZ791). This is a highly efficient method for small
plants, as no commissioning tools are required.
When commissioning larger systems with area/line couplers, IP routers and room
controllers or room thermostats, the OCI700.1 service tool/ACS790 software is
recommended.
The operator units provide the option of three access levels. The selected access
level is identified by the design of the square, top left. The following applies:
User level: Black square: Lowest access level, no password.
Service level: Square with key: Medium access level, no password.
Password level: Square with key 2: Highest access level, password.
Commissioning requires access to the password level. From the start page, the
user logs in with the password and navigates to the required operating page or
operating line via the predefined path.
Wednesday 28.05.2003
Welcome
« Information
Main menu»
Press the OK "press-and-select" knob on the operator unit to access the "Main
menu" page.
3.2.1

Start commissioning, plant mode "Off"

Before starting commissioning, it is recommended for safety and technical reasons
to switch off the plant, e.g. the fan run-on for electric heating coils.
However, this requires that the plant is enabled again when commissioning is
complete (see Section 3.2.2).
Main menu > Plant operation > Preselection
On the "Main menu" page, select "Plant operation".
Main menu
Commissioning...
Time switch...
Room operating mode...
Plant operation...
Press the OK knob to open the "Plant operation" page.
KNX bus communications
Commissioning notes
15:06
For internal use only
CE1P3127en
2013-04-08