Setting Switches - Toshiba JTNI6 Series Instruction Manual

Before installing the card in a personal computer, set the station address of the
card, using the switches on the side of the card. (Refer to Figure 2-1 The card
appearance)
Use a small flat-blade screwdriver for this purpose.
3.1

Setting Switches

• Station address setting: STN-H, STN-L (hexadecimal rotary switches)
TC-net 100 station address switches. Set an address unique to the same
segment. Up to 254 station addresses from 01h to FEh can be set.
Name
Station address
• Operation mode setting: MODE (4-bit DIP switches)
Keep all the DIP switches in the OFF position.
Bit No.
1 Reserved
2 Reserved
3 Synchronous node promotion
Prohibited/Permitted
4 Reserved
Table 3-1 Station Address Setting
Location
STN-H
STN-L
Set a station address in hexadecimals.
The address 28 corresponds to 1C in hexadecimals (h).
So, turn STN-H to 1 and STN-L to C.
Table 3-2 Operation Mode Setting
Function
Unified Controller TC-net 100 PCI express Card JTNI6 Instruction Manual
Setting
Setting range: 01 to FE (h)
H (H address) : 0 to F (h)
L (L address: 0 to F (h)
Normal
Remarks
Setting
OFF
OFF
OFF ON: Permitted , OFF: Prohibited
OFF
3.1 Setting Switches
11