Card Replacement - Toshiba JTNI6 Series Instruction Manual

Chapter 4 Installation and Wiring
4.4

Card Replacement

(1) Switch off the personal computer and check the LED to make sure that power
(2) Hold the connector lock on the TC-net 100 cable connected to the JTNI card
(3) Remove the cover from the personal computer, remove the M3 screws from
(4) When a new JTNI card is ready, set the setting switches to the same positions
(5) Install the new JTNI card in the personal computer and connect the cables
18
6F8C1450
• Before replacing the card, switch off the personal computer and
make sure that power is off.
CAUTION
is off.
with your fingers and unlock the connector. Pull out the cable. Similarly, pull out
the Ethernet cable.
Attach tags or seals to the line A/B and Ethernet cables for identification later.
the JTNI card with a Phillips screwdriver, and pull out the card.
as those on the removed card.
back to it, referring to Section 4.2 Installation.