Connection - Toshiba JTNI6 Series Instruction Manual

4.3

Connection

The card has TC-net 100 port for TN-A and TN-B (with MT-RJ optical connector),
and EN for Ethernet port (with RJ-45 modular connector) on the front panel.
Connect transmission cables to the TN-A, TN-B, and EN connectors as shown
below.
JTNI61/62 card
Commercial
Ethernet card
Category 5 twisted-pair
cable (cross; supplied
as a necessary)
 Clamping cables
After connecting the cables, clamp them so that the weight and bends of the
cables will not directly affect the connectors. The allowable bending radius for
the cables connected and clamps is shown in Table 4-1. Make sure that the
cable bends do not exceed the specified radius.
Cable
Optical fiber cable
Twisted-pair cable
Note: Optical fiber cables vary in allowable bending radius from one to another. Observe the
specified bending radius of the optical cable manufacturer.
Optical fiber cord with
MT-RJ connector
Figure 4-1 Installed External Views and
Wiring of Personal Computer with Cards
Table 4-1 Allowable Cable Bending Radius
Cable Outside
Diameter (mm)
5
5.2
Unified Controller TC-net 100 PCI express Card JTNI6 Instruction Manual

4.3 Connection

Ethernet port
TC-net 100 line A port
TC-net 100 line B port
Allowable Bending Radius (mm)
Clamped Connected
50 50
21 52
17