Field Of Application - Siemens SIPROCESS GA700 Compact Operating Instructions

Introduction

1.4 Field of application

Note
Use in home environment
This equipment of Class A Group 1 is intended solely for use in industrial areas.
If used in homes, the device may cause radio interference.
Note
For more information on the compatibility of the hardware and firmware, refer to:
Siemens Industry Online Support (https://support.industry.siemens.com/cs/de/en/ps/17731).
You will find more information in the operating instructions, see
"References (Page 106)".
1.4 Field of application
These compact operating instructions describe SIPROCESS GA700 devices approved for
operation in hazardous areas. They refer to the rack-mounted and wall-mounted devices
with analyzer modules permanently installed in the factory by the manufacturer that are used
depending on the measuring task and local conditions.
The following analyzer modules are available for explosion-proof devices:
● Standard analyzer modules OXYMAT 7, ULTRAMAT 7 and CALOMAT 7 for rack-
mounted and wall-mounted devices. Up to two analyzer modules possible per basic
device.
● High-temperature analyzer modules OXYMAT 7 and ULTRAMAT 7 only for wall-mounted
devices. Only one analyzer module possible per wall-mounted device.
Note
Special conditions
You must also take into consideration the special conditions described in the following listed
certificates. These conditions relate, in particular, to the following:
• Areas of application
• Requirements for operation in hazardous areas
• Other precautionary measures important for operation
Note
Deviating technical specifications
For operation of the below-indicated devices in hazardous areas, deviating technical
specifications may apply. The technical specifications listed in these Operating Instructions
are valid in such cases.
8
Devices in explosion-proof design
Compact Operating Instructions, 05/2018, A5E35134047-03