Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual page 105

To install the new controller, proceed as follows:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove it from
the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu support
service.
Step 2 Prepare the server
Enable PCI Option ROM scan for appropreated PCI slot in BIOS setup.
Shut down and power off the server.
Step 3 Install the new SAS RAID controller
Refer to your server specific Upgrade and Maintenance Manual for
information on the PCIe slot and installing the controller.
Step 4 Power-up the server
Start up the server. Ensure that the SAS and/or SATA II devices are
properly connected to the controller.
During booting, a message similar to the following is displayed:
LSI MegaRAID SAS-MFI BIOS Version NTxx (Build ..date..)
Copyright(c) 2014, LSI Corporation
HA-x (Bus x Dev y) PRAID EP420e (Dnnnn)
FW package: xxxx
Step 5 Run the BIOS Configuration Utility
Run the BIOS Configuration Utility to configure the physical arrays and
logical drives. Press CTRL+R immediately to run the utility, when the
following message appears on the screen:
Press <Ctrl><R> to Run MegaRAID Configuration Utility
Step 6 Install the operating system driver
The controller can operate under various operating systems. To use
these operating systems, you must install software drivers.
The ServerView Suite DVD 1 includes drivers for the supported
operating systems, along with documentation. You can view the
supported operating systems and download the latest drivers for RAID
adapters on the website at:
For Japan please use the URL:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
Modular RAID Controllers
Modular RAID 12Gb/s (SAS3.0)
http://ts.fujitsu.com/support/
105