Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual page 29

To install the LSliBBU01/LSliBBU07 remotely to the RAID controller, proceed as
follows:
1. Ground yourself, then remove the LSliBBU01/LSliBBU07 from its package.
2. Secure the LSliBBU01/LSliBBU07 to the server chassis as described in the
server documentation.
3. Insert the battery pack harness connector (at the end of the colored wires)
into the J2 connector (LSliBBU01, see
see figure 7) on the bottom of the iBBU.
4. Connect the cable from the cable connector (for LSliBBU01 see
for LSliBBU07 see
controller.
I
The connectors are marked with a black dot to indicate pin 1.
Edge of
Motherboard
Figure 8: Example: Installing the iBBU01 in a server chassis
Modular RAID Controllers
figure 7) on the iBBU to the BBU connector on the RAID
Modular RAID 3Gb/s (SAS1.0)
figure 6) or J4 connector (LSliBBU07,
Edge of Motherboard
figure 6 or
PIN1
29