Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual page 20

Modular RAID 3Gb/s (SAS1.0)
Step 4 Power-up the server
Replace the server cover and reconnect the power cable(s). Start up
the server. Ensure that the SAS and/or SATA II devices are powered
up before or at the same time as the host server. If the host server is
powered up before the SAS or SATA II devices, the devices might not
be recognized.
During booting, a message similar to the following is displayed:
LSI Logic Corp. MPT SAS Bios
MPTBIOS-6.12.00.00
Copyright 2000-2006 LSI Logic Corp.
Step 5 Run the LSI Logic Configuration Utility
Run the LSI Logic Configuration Utility to configure the physical arrays
and logical drives.
Press CTRL+C immediately to run the utility, when the following
message appears on the screen:
Press <Ctrl><C> to start LSI Logic Configuration
Utility
Step 6 Install the operating system driver
The controller can operate under various operating systems. To use
these operating systems, you must install software drivers.
The ServerView Suite DVD 1 includes drivers for the supported
operating systems, along with documentation. You can view the
supported operating systems and download the latest drivers for
RAID adapters on the website at:
For Japan please use the URL:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
20
(2006.10.31)
http://ts.fujitsu.com/support/
Modular RAID Controllers