Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual page 79

Step 3 Install the new SAS RAID controller
Insert the controller in a suitable PCIe slot on the system board. Press
down gently but firmly to ensure the controller is properly seated in the
slot. Secure the controller to the server chassis with the PCI card hold
down latches. Connect the SAS and/or SATA HDDs located in the
system to the SAS cable connector(s) on the controller. Refer to your
server specific Upgrade and Maintenance Manual for information on
the PCIe slot and installing the controller.
Step 4 Power-up the server
Replace the server cover and reconnect the power cable(s). Start up
the server. Ensure that the SAS and/or SATA II devices are properly
connected to the controller.
During booting, a message similar to the following is displayed:
LSI MegaRAID SAS-MFI BIOS Version NTxx (Build ..date..)
Copyright(c) 2014, LSI Corporation
HA-x (Bus x Dev y) PRAID EP400i / EP420i (D3216)
FW package: xxxx
Step 5 Run the BIOS Configuration Utility
Run the BIOS Configuration Utility to configure the physical arrays
and logical drives. Press CTRL+R immediately to run the utility, when
the following message appears on the screen:
Press <Ctrl><R> to Run MegaRAID Configuration Utility
Step 6 Install the operating system driver
The controller can operate under various operating systems. To use
these operating systems, you must install software drivers.
The ServerView Suite DVD 1 includes drivers for the supported
operating systems, along with documentation. You can view the
supported operating systems and download the latest drivers for
RAID adapters on the website at:
For Japan please use the URL:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
Modular RAID Controllers
Modular RAID 12Gb/s (SAS3.0)
http://ts.fujitsu.com/support/
79