Operation With At Least One Ultramat 7; Operation With At Least One Calomat 7 - Siemens SIPROCESS GA700 Operating Instructions Manual

Table 5- 1
Operating
mode
Pressure
operation
Suction op-
eration
5.4.4

Operation with at least one ULTRAMAT 7

Table 5- 2
Operating mode
Pressure operation/Suction operation
5.4.5

Operation with at least one CALOMAT 7

Table 5- 3
Operating mode
Pressure operation/Suction operation
Wall-mounted device
Operating Instructions, 05/2018, A5E31930403-06
Mounting position of the sample gas restrictor: OXYMAT 7
Sample gas restrictor/clamping screw
Operation with one
OXYMAT 7
Install a sample gas re-
strictor in front of the sam-
ple gas inlet.
Install a sample gas re-
strictor in the sample gas
outlet
Mounting position for the sample gas restrictor: ULTRAMAT 7
Mounting position for the sample gas restrictor: CALOMAT 7
Operation with two
OXYMAT 7 in series
Install a sample gas re-
strictor in front of the sam-
ple gas inlet into which the
sample gas is introduced
first.
In addition replace the
sample gas restrictor in the
inlet of the rear, second
module with a clamping
screw.
Install a sample gas re-
strictor in the sample gas
outlet from which the sam-
ple gas is first sucked out:
In addition replace the
sample gas restrictor in the
inlet of the rear, second
module with a clamping
screw.
Sample gas restrictor/clamping screw
Operation with one or two ULTRAMAT 7
No sample gas restrictor/clamping screw required Subse-
quent upgrading or retrofitting is not possible and not re-
quired.
There are no particular mounting restrictions.
Clamping screw
Operation with one or two CALOMAT 7
Pre-assembled clamping screws. No retrofitting or disman-
tling required.
Combined operation
5.4 Application planning
Operation with two
OXYMAT 7 in parallel
Install a sample gas re-
strictor in front of each
sample gas inlet.
Install a sample gas re-
strictor at each sample gas
outlet
43