Siemens SIPROCESS GA700 Operating Instructions Manual page 94

Connecting the device
8.2 Electrical connections
2. Fasten the prepared gland at the device:
⑥
⑦
Figure 8-8
– Fasten the Ethernet cable in the cable gland
Connecting the Ethernet cable
1. Isolate the free cable end.
2. Assemble the stripped cores in a FastConnect plug.
3. Insert the Ethernet plug into the service interface of the processing module. You must feel
for the position of the interface.
94
Plate with cable glands
Position cable gland Ethernet cable (underside of the device)
Ethernet cable: Position of the cable gland
⑦ ⑥
at the plate .
Operating Instructions, 05/2018, A5E31930403-06
Wall-mounted device