Cleaning The Dust Filter; Cleaning The Uv-C Lamp - Silvercrest SMS 300 A1 Operating Instructions And Safety Instructions

Cleaning the dust filter

♦
After you have removed the dust filter
the dust filter
filter
♦
Wait until the dust in the plastic bag has settled and then remove the dust
filter
afterwards .
♦
If necessary, you can rinse out the dust filter
water . Allow the dust filter
♦
After cleaning, replace the dust filter
firmly seated .
♦
Replace the empty dust container
recess for the dust container
NOTE
► New dust filters
(see section Ordering spare parts) .

Cleaning the UV-C lamp

WARNING! RISK OF INJURY!
► The UV-C lamp
down sufficiently after use . Otherwise, there is a risk of burns .
♦
Use a screwdriver to loosen the screw on the cover
and remove the cover
♦
Wipe the UV-C lamp
NOTE
♦
Be careful not to touch the UV-C lamp
♦
Put on the cover
■ 12 │ GB │ IE │ NI │ CY
in a plastic bag . Close the plastic bag and knock the dust
4
out carefully .
4
from the plastic bag . Close the plastic bag again and dispose of it
4
4
can be reordered from the customer service
4
gets hot during use . Allow the UV-C lamp
8
.
e
with a dry duster .
8
and fix it again with the screw .
e
from the dust container
4
with fresh cold or lukewarm
4
to dry out completely .
in the dust container
4
with the inserted dust filter
3
on the appliance .
3
with your fingers .
8
, place
3
so that it is
3
in the
4
to cool
8
of the UV-C lamp
e 8
SMS 300 A1