Cleaning The Filters And Dust Collector - Silvercrest 359294 2010 Assembly, Operating And Safety Instructions

Cleaning the filters
and dust collector
Clean the filters (HEPA filter
and stainless steel filter
every two or three uses. Other-
wise the vacuum function will be
reduced and the product could
be damaged.
Do not wash the filters (HEPA
filter and stainless steel filter
25
) in the dishwasher or wash-
27
ing machine.
Do not clean the HEPA filter
under running water.
Do not clean the dust collector
in the dishwasher.
21
Allow the stainless steel filter
to air dry thoroughly after clean-
ing.
Do not put the stainless steel
filter in the dryer or on the
27
stove to dry.
IMPORTANT: Allow all parts
of the product to dry thoroughly
after cleaning. If the stainless
steel filter
27
ter may seep into the product
and damage it!
To clean the filters, follow these steps:
Switch the product off using the On / Off
button (see Fig. A).
19
Remove the aluminium suction tube
the main unit by pushing the upper release
4
25
) after
27
25
27
is not fully dry, wa-
from
16
button and removing the aluminium suction
20
tube from the main unit
16
Remove the dust collector
unit by pushing the release button
base of the dust collector
removing the dust collector
Ensure that the dust collector
chapter "Emptying the dust collector"). Tap the
dust collector out again over a waste bin if
21
needed.
Remove the cover of the dust collector
24
by turning it to the right until the marking on the
cover is above the
24
cover , pulling it upwards.
24
Take the entire filter unit out of the dust collec-
tor .
21
Remove the HEPA filter
25
by pulling it out upwards on the flap.
26
.
4
from the main
21
on the
22
and carefully
21
(see Fig. H).
21
is empty (see
21
21
- symbol. Remove the
24
from the filter carrier
GB/IE/NI/CY 19