Cleaning And Maintenance; Cleaning; Maintenance / Removing / Assembling The Cutting Blade; Special Accessories - Silvercrest SAS 150 A1 Operation And Safety Notes

Cleaning and maintenance

©
Cleaning and maintenance
©

Cleaning

Important safety advice for
cleaning the slicer
1. Before starting to clean the electric Multi-Pur-
pose Slicer; switch it off, remove the power ca-
ble 8 from the mains socket and set the food
support plate 13 into the „0" setting.
2. Do not submerse the electric Multi-Purpose
Slicer in water.
3.
ATTENTION! RISK OF SERIOUS
INJURY: The cutting blade
Accessories suitable
for dishwashers!
Clean the food carriage
and the catch-tray
It is necessary to clean the electric Multi-Pur-
pose Slicer thoroughly at regular intervals as
perishable food scraps could accumulate on
the appliance or behind the cutting blade
Clean all appliance parts not suitable for the
dishwasher with a lightly moistened cloth.
Wipe off the appliance housing
blade covering
6
guide slots and the food support plate
9
carefully. Do not use abrasive cleaning agents,
sponges with rough surfaces or hard brushes.
Cleaning brush:
ATTENTION! RISK OF PERSONAL INJU-
RY! Carry out all tasks using the cleaning brush
with great care. Should it slip close to the
19
cutting blade , there is the risk of receiving a
12
severe personal injury.
Use the bristles of the cleaning brush
move remnants such as crumbs from all difficult
to reach positions. The flattened end can be
excellently used to remove stubborn soiling.
34 GB/MT
is very sharp!
12
, the food holder
10
in the dishwasher.
17
, the cutting
5
, the support table with
19 to re-
©
Maintenance / Removing /
assembling the cutting blade
Important safety notices for
the removal and assembly of
the cutting blade!
1. Switch the slicer off, remove the plug from the
power socket and set the food support plate
into position „0".
2.
ATTENTION! RISK OF PERSONAL
INJURY! The cutting blade
For the removal and assembly wear appropriate
safety gloves. Otherwise, you could receive cut
injuries.
Open the blade cover
blade cover unlock button
blade cover
Remove the plastic screw clip
mounting and screw the blade lock of the cut-
ting blade
11
When taking out the blade
you grasp it at its centre.
The cutting blade
dishwasher.
12 . Clean the housing behind the cuttingblade
with a dry cloth or a soft brush.
Re-assemble the cutting blade
sequence of the above instructions.
Due to the special sawtoothing and the high
quality, the cutting blade
13
sharpness for a very long time. A resharpening
of the cutting blade is not necessary. Consult
the service centre for your country if you have
questions about the cutting blade
©

Special accessories

Round cutter:
An untoothed cutting blade, specifically for the
finest of slices, is also available.
Orders for special accessories are be directed to
the service centre for your country.
12 is very sharp!
by pressing the
6
. Remove the
4
.
6
from the
18
out by unscrewing it to the left.
12
make sure that
12
12 can be cleaned in the
12 in a reverse
will retain its
12
12
13
12
.