Table of Contents
Advertisement
Do not use the damaged, cracked or frayed electrical cables and connectors. Protect the
electrical cables from physical or mechanical abuse, such as being twisted, kinked, pinched,
closed in a door or walked upon. Periodically examine the electrical cables of your product, and
if its appearance indicates damage or deterioration, discontinue use of this product, and have
Ensure that you connect the earth ground wire to prevent possible electric shock. Do not try
to ground the product by connecting it to telephone wires, lightning rods or gas pipes.
liquids, such as vases, should be placed on the product.
Do not block any ventilation openings. Ensure reliable operation of the product and protect it
from over heating. The openings shall never be blocked by placing any object on this product.
The temperature of metal enclosure may be high during operation.
In order to avoid radio-interference, all accessories (like a energy meter) intended for
connection to the product shall be suitable for use in residential, commercial and light-industry
EN55022.
The product must be disposed of according to local regulations.
The electrical installation of this unit must only be performed by LGE service person or trained
If the AC circuit breaker is turned off and the PCS is not operated for a long time, the battery
may be overdischarged.
Connect the DC+ and DC- cables to the correct DC+ and DC- terminals on the product.
Danger of damaging the PCS by overload. Only connect the proper wire to DC terminal block.
Refer to the installation wiring diagram for details.
Do not step on the product or the product package. The product may be damaged.
Do not open or damage batteries. Released electrolyte is harmful to the skin and eyes. It may
be toxic.
A battery can present a risk of electrical shock and high short-circuit current. The following
precautions should be observed when working on batteries.
a) Remove watches, ring, or other metal objects.
b) Use tools with insulated handles.
c) Wear rubber bloves, boots and glasses
d) Do not lay tools or metal parts on top of battery.
Do not leave the ESS in the Fault standby state for a long time because of the battery
discharge may occur during the long standby state.
If the battery fault occurs immediately after starting PCS it means Battery failure. Check the
battery SOC also voltage and fault information, and turn off the power of the ESS until service
action is taken.
Getting Started
3
1
Advertisement
Table of Contents
