Silvercrest SFPW 360 B1 User Manual page 11

Once the power supply has been established, there
will be a beep, the display will light up and go
through a brief check of the display elements . After-
wards, the device will automatically attempt to receive
the WWVB signal . The reception icon
the display . If the reception icon is not flashing com-
pletely ( ) on the display, it means that the reception
of the WWVB signal is too weak and the time cannot
be synchronized . Try to find a set-up location where
the reception icon flashes completely ( ) on the
display .
If the WWVB signal is being received correctly, the
current Eastern standard time (EST) is shown on the
display . In addition, the reception icon
ly shown on the display .
The default time zone of the device is Eastern
Standard Time (EST). To change the time zone
please refer to Setting the date and time
manually section.
If the device is unable to synchronize with the
WWVB signal, you can also set the time manu-
ally (see Setting the date and time manually
section) or you can attempt automatic reception
again.
♦ Press and hold the °C /°F
3 seconds until the reception icon
the display . The device makes another reception
attempt .
SFPW 360 B1
_330014_SFPW360B1_LB9.indb 11
flashes on
is permanent-
button 7 for about
flashes on
│
11
US - EN
■
03.09.19 12:2