Epson Stylus Color 1520 Service Manual page 80

&2/25
EPSON Stylus 1520
3.2.3.2 Color Printhead Removal
1. Remove the upper housing. (Refer to Section 3.2.1.)
2. Remove the ink cartridge if it is installed.
3. Remove the FFC holders from the front left corner of the CR unit. Then release the FFCs by pulling them
toward the printhead side.
4. Disconnect the color FFC from the color head connector.
5. Remove the cartridge lever.
6. Remove the compression spring mounting the black printhead to the CR unit.
7. Remove the screw securing the color printhead to the CR unit.
8. Shift the color printhead forward then remove it by lifting upward.
;
When removing the black printhead, be careful not to catch the color printhead FFC.
;
Be careful not to damage the printhead FFCs when pulling them from the corner of the CR unit.
;
After replacing the printhead, make the following adjustments:
(Refer to Chapter 4, Adjustments.)
T
Write printhead data
T
Adjust printhead angle
T
Adjust printhead vertical
T
Adjust printhead gap
3-8
WORK POINT
REQUIRED ADJUSTMENT