Silvercrest SMAS 500 A1 Operating Instructions Manual page 28

♦ Remove the container
milk to reach the MIN mark (= 75 ml) inside the container
you should never fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will spill over:
–
up to the lower MAX marking
–
up to the upper MAX marking
the milk
♦ Place the container
♦ Put the lid
♦ Use the function button
–
Press once = heat milk with stiff froth
–
Press twice = heat milk with creamy froth
–
Press three times = heat milk with only a little froth
–
Press four times = froth milk without heating
The control lamp
cold). The selected programme starts automatically.
♦ The appliance switches off automatically at the end of the programme, the
control lamp
If you want to stop the preparation process before completion, press the
Function button
have to reselect the programme when you resume the preparation process.
♦ Remove the lid
container.
♦ Allow the appliance to cool down for about 2 minutes before you froth up
another portion of milk. Otherwise the appliance will automatically trigger the
overheating protection after five successive cycles. The control lamps
and you cannot make any entries. The appliance is ready for use again after
around five minutes.
SMAS 500 A1
from the base
on the base
on.
to select the appropriate programme:
for the relevant programme lights up (red = hot, blue =
goes off.
or remove the appliance from the base
and pour the milk and/or the milk froth into the desired
and fill it with milk. Add enough
(= 150 ml), if you want to froth milk
(= 300 ml), if you only want to heat
.
GB │ IE
. However,
. You will
flash
│ 25 ■