Subtracting Single-Precision Real Numbers - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Subtracting single-precision real numbers

E-
This instruction performs subtraction between single-precision real numbers.
ST
ENO:=EMINUS(EN,s1,s2,d);
■Execution condition
Instruction
E-
Setting data
■Description, range, data type
Operand Description
(s1) Minuend data or the start device where minuend data is stored
(s2) Subtrahend data or the start device where subtrahend data is stored
(d) Start device for storing the operation result
EN Execution condition
ENO Execution result
■Applicable devices/labels
Operand Bit
SB
(s1)

(s2)

(d)

Processing details
• This instruction subtracts the single-precision real number in the device specified by (s2) from the single-precision real
number in the device specified by (s1), and store the result in the device specified by (d).
(s1)+1 (s1)
Single-precision real number Single-precision real number
-126
• Value 0 or 2 ≤|specified value (stored value)| <2
(d).
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 26 Precautions
Operation error
Error code Description
3402H The value input to (s1) is -0, a subnormal number, NaN (not a number), or ±∞.
The value input to (s2) is -0, a subnormal number, NaN (not a number), or ±∞.
3403H The data in the device specified by (d) exceeds the following range. (An overflow has occurred.)
|(d)|<2
10 REAL VALUE PEOCESSING
106
10.1 Floating-point instruction
Execution condition
RX, RY, LB



(s2)+1 (s2)
-
128
Range
0, 2
0, 2



Word
SW



(d)+1 (d)
Single-precision real number
128
can be specified or stored in the devices specified by (s1), (s2), and
Data type
-126 128
ANYREAL_32
≤|(s1)|<2
-126 128
ANYREAL_32
≤|(s2)|<2
ANYREAL_32
BOOL
BOOL
Constant
G, RWw, RWr, LW K, H
 
 
 