Maintenance; Recommended Maintenance Schedule(S) - Toro SGR-6 Operator's Manual

Stump grinder
Table of Contents

Advertisement

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Important:
You can tip the machine backward or on its side to clean or service it, but no longer than 2
minutes. If you hold the machine in this position for too long, fuel can drain into the crankcase and
damage the engine. Should this happen, perform an extra oil change on the engine, then turn the engine
over a few revolutions with the starter handle before starting the engine again.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 20 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 300 hours
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Maintenance Procedure
• Change the engine oil.
• Check the air filter (more often in dirty or dusty conditions).
• Check the engine-oil level.
• Clean the engine screen.
• Check the condition of the teeth; rotate or replace any that are worn or damaged
and torque the nuts for all teeth.
• Remove debris from the machine.
• Check the drive-belt tension.
• Service the air filter
• Change the engine oil. (Service more frequently if conditions are extremely dusty
or sandy.)
• Check the spark plug.
• Clean the sediment cup.
• Replace the air filter.
• Replace the spark plug.
• Change the engine oil.
• Clean the sediment cup.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

2260022600hd

Table of Contents