Specifications; Attachments/Accessories - Toro SGR-6 Operator's Manual

Throttle Lever
The throttle lever controls the engine speed. With
the lever released, in the D
engine runs at idle. This is also the starting position.
When you pull the lever to the handle, the engine
speed increases, the centrifugal clutch engages, and
the cutting wheel rotates.
1. Throttle lever
Parking Brake
The parking brake holds the left wheel from turning to
secure the machine and for easy movement of the
machine from side to side when grinding a stump
(Figure 7).
1. Parking brake (engaged)
position, the
ISENGAGED
Figure 6
2. Safety bail
Figure 7
2. Parking brake
(disengaged)
Choke Lever
Use the choke lever
Before pulling the recoil-start handle, move the choke
lever to the C
LOSED
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
Recoil-Start Handle
To start the engine, pull the recoil-start handle
3) quickly to turn the engine over. Refer to
Engine (page 11)

Specifications

Note:
Specifications and design are subject to
change without notice.
Cutting Depth
Length
Width
Height
Weight
g014874

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
g243949
8
(Figure 3) to start a cold engine.
position. Once the engine is
PEN
for the correct starting procedure.
30 cm (12 inches)
127 cm (50 inches)
56 cm (22 inches)
107 cm (42 inches)
position.
(Figure
Starting the
47 kg (103 lb)