Installing the Weight Rod
1.
Enlarge the lower hole on the right side of the
cutting unit using a 9 mm (23/64 inch) drill bit
(Figure
5).
2.
Lubricate the O-ring on the weight rod.
3.
Insert the O-ring end of the weight rod into the
previously drilled hole.
4.
Secure the threaded end of the weight rod to the
frame using a flange-head bolt
1. Flange-head bolt
Figure 5
(Figure
6).
Figure 6
2. Weight rod
Installing the Push Nut (CE
Only)
1.
Loosen the flange bolt securing the belt cover
and remove the belt cover.
2.
Slide the push nut onto the belt cover plug
(Figure
7).
g026123
1. Push nut
3.
Install the belt cover.
Adjusting the Cutting Unit
1.
Support the cutting unit; refer to
Cutting Unit (page
2.
Adjust the bedknife to the reel; refer to
the Bedknife to Reel Contact (page
3.
Adjust the rear roller height; refer to
the Rear Roller Height (page
4.
Adjust the height of cut; refer to
Height of Cut (page
5.
Adjust the cut-off bar; refer to
g026124
Cut-Off Bar (page
6.
Set up and prepare the cutting unit as described
in the traction unit Operator's Manual.
6
Figure 7
2. Belt-cover plug
Supporting the
8).
Adjusting
8).
Adjusting
11).
Adjusting the
11).
Adjusting the
14).
g027722