Adjusting The Control-Arm Position; Installing The Cutting Units - Toro Reelmaster 5510 Operator's Manual

2
Adjusting the Control-Arm
Position
No Parts Required
Procedure
You can adjust the control-arm position your comfort.
1. Loosen the 2 bolts securing the control arm to
the retaining bracket
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position
and tighten the 2 bolts.
(Figure 3).
Figure 3
3. Bolts (2)
3

Installing the Cutting Units

Parts needed for this procedure:
1 Right front hose guide
1 Left front hose guide
Preparing the Machine
1. Remove the reel motors from the shipping
brackets.
2. Remove and discard the shipping brackets.
3. At each cutting unit lift arm, remove the snapper
pin that secures the cap to the lift arm pivot
yoke, and remove the cap
g004152
1. Snapper pin
Preparing the Cutting Units
1. Remove the cutting units from the cartons.
2. Assemble and adjust as described in the cutting
unit Operator's Manual.
3. Make sure that the counterweight
installed at the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
10
(Figure 4).
Figure 4
2. Cap
(Figure
g003975
5) is