Replacing The Tec Fuse; Drive System Maintenance; Checking The Tire Air Pressure; Checking The Torque Of The Wheel Nuts - Toro Reelmaster 5510 Operator's Manual

Figure 95

Replacing the TEC Fuse

1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood; refer to
Hood (page 44).
3. At the front, left side of the engine, remove the
cover of the in-line fuse holder.
Figure 96
1. TEC fuse
4. Replace the open fuse with a fuse of the same
type and amperage rating.
5. Assemble the cap to the in-line fuse holder.
6. Close and latch the hood; refer to
Hood (page 44).
Drive System
Maintenance
Checking the Tire Air
Pressure
Service Interval: Before each use or daily
Important:
g419732
in all tires to ensure a good quality of cut and
proper machine performance. Do not underinflate
the tires.
1.
2.
44).
Opening the
3.
4.
Checking the Torque of the
Wheel Nuts
Service Interval: After the first hour
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Maintain the proper torque on the wheel nuts.
1.
2.
g422229
Checking the Rear-Wheel
Alignment
Service Interval: Every 800 hours—Check the rear
Closing the
1.
2.
3.
58
Maintain the recommended pressure
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Measure the tire air pressure.
Note:
The correct air pressure in the tires is 83
to 103 kPa (12 to 15 psi).
If needed add air to or remove air from the tire.
Repeat steps 2 and 3 at the other tires.
After the first 10 hours
Every 250 hours
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Torque the wheel nuts to 94 to 122 N∙m (70 to
90 ft-lb).
wheel toe-in.
Rotate the steering wheel to position the rear
wheels straight ahead.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
At axle height, measure the center-to-center
distance at the front and rear of the steering
tires.
44).
44).
44).