Toro Reelmaster 5510 Operator's Manual page 16

Figure 24
1. Cap
2. Snapper pin
2. Assemble the pivot yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot yoke and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot arm shaft and cap to the carrier
frame shaft with the snapper pin.
5. Lock the cutting-unit pivot for cutting grass on a
hill side; refer to
for Cutting Grass on a Hill Side (page
6. Repeat steps 1 and
unit.
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1. Remove the lynch pin and washer securing the
pivot yoke to the lift arm and slide the shaft out
of the lift arm (Figure
3. Pivot yoke
4. Carrier frame shaft
Locking the Cutting-Unit Pivot
17).
2 for the other rear cutting
25).
1. Lynch pin
2. Pivot yoke
2. Assemble the pivot yoke onto the carrier frame
shaft (Figure
g375252
1. Cap
2. Snapper pin
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot yoke and cap to the carrier
frame shaft with the snapper pin.
5. Lock the cutting-unit pivot for cutting grass on a
hill side; refer to
for Cutting Grass on a Hill Side (page
6. Slide a cutting unit under the lift arm
16
Figure 25
3. Lift arm (rear cutting unit)
4. Washer
26).
Figure 26
3. Pivot yoke
4. Carrier frame shaft
Locking the Cutting-Unit Pivot
g375236
g375237
17).
(Figure 27).