Setup; Preparing The Machine - Toro Reelmaster 5510 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the
cutting units, and engage the parking brake.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Check the tire air pressure before use; refer to
Checking the Tire Air Pressure (page
Note:
The tires are overinflated for shipping.
Adjust the tire air pressure before operating the
machine.
4. Check the hydraulic-fluid level; refer to
the Hydraulic-Fluid Level (page
5. Grease the machine; refer to
Bearings and Bushings (page
Important:
Failure to properly grease the
machine will result in premature failure of
critical parts.
Description
No parts required
No parts required
Right front hose guide
Left front hose guide
Cutting-unit kickstand
Production year decal
58).
Checking
63).
Greasing the
46).
Qty.
–
–
1
1
1
1
Qty.
1 Read the manuals before operating the machine.
1 Use the manual to reference engine information.
6. Open the hood and check the coolant level; refer
to Checking the Coolant Level (page
7. Check the level of the engine-oil level, and close
and latch the hood; refer to
of the Engine Oil (page
Note:
crankcase; however, check the oil level before
and after the engine is first started.
9
Use
Prepare the machine.
Adjust the control-arm position.
Install the cutting units.
Install the cutting-unit kickstand.
Apply the production year decal.
Use
Checking the Level
49).
The engine ships with oil in the
60).