Removing Debris From The Cooling System - Toro Reelmaster 5510 Operator's Manual

6. Close and latch the hood; refer to
Hood (page 44).
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (More
frequently in dirty operating
conditions).
Every 100 hours—Inspect the cooling system
hoses.
Every 2 years—Flush and replace the cooling
system fluid.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
44).
3. Thoroughly clean all debris out of the engine
area.
4. Close and latch the hood; refer to
Hood (page 44).
5. Unlatch the rear screen and pivot it open
100).
Figure 100
1. Latch
6. Thoroughly clean the screen with compressed
air.
7. Rotate the 2 oil-cooler latches inward, and tilt
oil cooler (Figure
Closing the
44).
Opening the Hood (page
Closing the
2. Rear screen
101).
1. Oil cooler
8. Thoroughly clean both sides of the oil cooler and
the radiator
(Figure
1. Radiator
g004138
9. Raise the oil cooler and secure it with the 2
latches.
10. Close and latch the screen.
61
Figure 101
2. Oil-cooler latches
(Figure 102) with compressed air.
Figure 102
g003974
g004137