Toro Reelmaster 5510 Operator's Manual page 14

Figure 17
1. Hairpin
2. Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (Figure 18).
Figure 18
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3. Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit (Figure
Note:
Do not remove the flange serrated nut
from the capscrew.
3. Flange locknut (3/8 inch)
19).
1. Capscrew
2. Right tab (Carrier frame)
4. Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
20) with the flange locknut (3/8 inch).
g375689
1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame
g375690
21).
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
14
Figure 19
3. Flange locknut (3/8 inch)
Figure 20
3. Capscrew
g375691
(Figure
g375694
(Figure