Hitachi CS 33EDP Service Manual page 10

Engine

Hide thumbs Also See for CS 33EDP:

2. Disassembly and reassembly of the front handle

[Tools required]

• Phillips screwdriver

• Flat-blade screwdriver

• Box-end wrench 10 x 19 mm

• Socket wrench (10 mm)

(1) Disassembly

• Use a Phillips screwdriver to remove the two Tapping Screws (W/Flange) D5 x 25 (Black) [193]. Use

a flat-blade screwdriver to remove the Flange Nut M6 [165], and then use a box-end wrench 10 x 19

mm to remove the Front Handle [195]. (See the figure "Tightening the Flange Nut M6 [165]" on the

next page.)

• Use a 1 0-mm wide box wrench (socket type) to r emove the Antivibration Spring [161].

(2) Reassembly

Reassembly can be conducted by reversing the disassembly procedure. However, special attention

should be given to the following items.

• Reassemble the anti-vibration mechanism of the Front Handle [195] by following the procedure

below.

• Front handle

Spring Cover [196]

Antivibration Spring [161]

Bolt Washer M6 [62]

Damper Set Bolt [197]

Spring Holder [159]

Tapping Screw (W/Flange)

D5 x 25 (Black) [193]

Flange Nut M6 [165]

-9-

Front Handle [195]

Cs 33ed