Hitachi CS 33EDP Service Manual page 20

8. Wiring diagram
(1) See pages 20 and 23 for wiring of Cord (A) [83] and the Cord [78].
• Connect the terminal of the Ignition Coil [82] with the silver side of Cord (A) [83].
• Connect the round terminal side of the Cord [78] with the Ignition Coil [82] by using the Hex. Socket Hd.
Bolt (W/Flange) M4 x 18 [79].
• Pass Cord (A) [83] and the Cord [78] through the hole on the Engine Case Ass'y [51].
• Insert Cord (A) [83] and the Cord [78] into Cord Insulation Tube L60 [76], and then store Cord
Insulation Tube L60 [76] in the hole on the Engine Case Ass'y [51].
• Pass Cord (A) [83] and the Cord [78] through the hole on the Rear Handle [166] in which the Stop
Switch [147] is stored, and then connect both with the terminals of the Stop Switch [147].
• Insert the Stop Switch [147] into the Rear Handle [166].
(2) See pages 20 and 22 for wiring of the high tension cord.
• Pass the high tension cord of the Ignition Coil [82] through the Engine Case Ass'y [51].
• Apply a small quantity of oil onto the tip of the high tension cord, and then insert it into the Spark Plug
Cap [77].
• Mount Metal Fitting of Plug Cap (A) [80] so that it penetrates the core wire of the high tension cord.
• Pull the high tension cord and store Metal Fitting of Plug Cap (A) [80] in the Spark Plug Cap [77].
9. Connecting the fuel pipes
Make the connections as illustrated on pages 20 and 21.
• Fully insert the pipes down to their roots.
• Do not bend or twist the pipes.
• Be careful not to get pipes caught by other parts.
• The end faces of the Fuel Pipe (FKM) [163] and Fuel Pipe L220 [164] should protrude from the edge of
the Fuel Grommet [162] by 152 to 162 mm and 191 to 201 mm, respectively.
CAUTION: Never mix up fuel pipes inserted into the Priming Pump Comp. [169].
-19-