Driving The Machine; Shutting Off The Engine; Moving A Non-Functioning Machine - Toro 320-D Operator's Manual

Driving the Machine

Use the traction controls to move the machine. The
farther you move the traction controls in any direction,
the faster the machine moves in that direction.
Release the traction controls to stop the machine.
CAUTION
When reversing, you may back into stationary
objects or over bystanders and cause serious
personal injury or death.
Look behind you for obstructions or
bystanders and keep your hands on the
reference bar.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle lever in the F
AST
You can, however, use the throttle position to operate
at slower speeds.

Shutting Off the Engine

1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2. Ensure that the auxiliary hydraulics lever is in
the N position.
EUTRAL
3. Move the throttle lever to the S
4. If the engine has been working hard or is hot, let
it idle for a minute before turning the key switch
to the O position.
FF
Note:
This helps to cool the engine before you
shut it off. In an emergency, you can shut off
the engine immediately.
5. Turn the key switch to the O
remove the key.
CAUTION
A child or untrained bystander could attempt
to operate the traction unit and be injured.
Remove the key from the key switch when
leaving the traction unit, even if just for a few
seconds.
position for best performance.
position.
LOW
position and
FF
Moving a Non-Functioning
Machine
Important:
Do not tow or pull the machine
without first opening the tow valves, or you will
damage the hydraulic system.
1. Shut off the engine.
2. Remove the plug covering each tow valve
(Figure 14).
3. Loosen the jam nut on each tow valve.
4. Turn each valve counterclockwise 1 turn with a
hex wrench to open them.
5. Tow the machine as required.
Important:
Do not exceed 4.8 km/h (3 mph)
when towing.
6. After repairing the machine, close the tow valves
and tighten the jam nuts.
Important:
Do not overtighten the tow
valves.
7. Replace the plugs.
22
Figure 14
g005942