Using Attachments - Toro 320-D Operator's Manual

Using Attachments

Installing an Attachment
Important:
Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the machine. The
warranty of the machine may be voided if you use
the machine with unapproved attachments.
Important:
Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins
do not rotate freely, grease them.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
machine.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position the mount plate into the upper lip of the
attachment receiver plate
Figure 15
1. Mount plate
5. Raise the loader arms while tilting back the
mount plate at the same time.
Important:
Raise the attachment enough to
clear the ground and tilt the mount plate all
the way back.
6. Shut off the engine and remove the key.
7. Engage the quick-attach pins, ensuring that they
are fully seated in the mount plate
Important:
If the pins do not rotate to the
engaged position, the mount plate is not
fully aligned with the holes in the attachment
receiver plate. Check the receiver plate and
clean it if necessary.
(Figure 15).
g003710
2. Receiver plate
(Figure 16).
1. Quick-attach pins
(engaged position)
2. Disengaged position
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
23
Figure 16
3. Engaged position
g003711