Lubrication; Greasing The Machine - Toro 320-D Operator's Manual

Figure 24
1. Cover
5. Pull the cover off the machine.
6. When finished, replace the front-access cover
and secure it with the 2 locking tabs.
Opening the Rear-Access Cover
1. Shut off the engine and remove the key.
2. Release the 2 locking tabs on top of the
rear-access cover
Figure 25
1. Rear-access cover
2. Locking tabs
3. Remove the bolt located next to the right locking
tab (Figure 25).
4. Grasping the handle, pull the cover up and back
to swing it open (Figure
5. When finished, close the rear-access cover by
swinging it up and seating it in place.
6. Secure it with the 2 locking tabs and bolt.
2. Locking tab
(Figure 25).
3. Bolt
25).

Lubrication

Greasing the Machine

Service Interval: Before each use or daily (Grease
Grease Type: General-purpose grease.
1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
g005943
2. Shut off the engine and remove the key.
3. Clean the grease fittings with a rag.
4. Connect a grease gun to each fitting
and Figure
g005957
5. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6. Wipe up any excess grease.
29
immediately after every washing.)
27).
Figure 26
Figure 27
(Figure 26
g005945
g004209