EMU36510
Checks after starting engine
EMU36522
Cooling water
Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole indicates that the water
pump is pumping water through the cooling
water passages. If the cooling water passag-
es are frozen, it may take a while for water to
start flowing out of the pilot hole.
ECM01810
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
the cooling water inlet on the lower case or
the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU27670
Warming up engine
EMU35264
Electric start models
After the engine has started, warm the engine
up until the engine speed settles at idling
speed.
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU36980
Stop switches
Turn the main switch to "
G
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
G
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
G
with the clip removed from the engine shut-
off switch.
EMU35880
Selecting outboard motor (tri-
ple engine)
After all engines have started, set all control
levers to Neutral. Push the engine selector
switch repeatedly to change the digital elec-
tronic control-active indicator and select the
desired engine.
Operation
", or press the
49