Accessing Internal Components - Toro TX 1000 Operator's Manual

Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and screens
while the engine is running could allow you to
contact moving parts, seriously injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key from
the key switch, and allow the engine to cool.
Opening the Hood
1. Loosen the hood-locking screw
Figure 34
1. Hood-locking screw
2. Hood-latch lever
2. Turn the hood latch clockwise
3. Lift up on the handles and swing the hood up
34).
4. Secure the prop rod.
(Figure 34)
g031215
3. Hood
(Figure 34).
(Figure
Closing the Hood
1. Lift up on the tab securing the prop rod
1. Prop-rod tab
2. Lower the hood and secure it by pushing down on the
front of the hood until it locks in place.
3. Tighten the hood-locking screw to secure the latch
(Figure 34).
Opening the Rear-Access Cover
1. Remove the fastener
1. Fastener
2. Lift the rear-access cover up to access the internal
components (Figure
3. Lower the rear-access cover and install the fastener to
close the cover.
27
(Figure
Figure 35
(Figure 36).
Figure 36
36).
35)
g031216
g031217