Storage - Toro TX 1000 Operator's Manual

Storage

1. Park the machine on a level surface, engage the parking
brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Remove dirt and grime from the entire machine.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
4. Service the air cleaner; refer to
Cleaner (page 30).
5. Grease the machine; refer to
(page 29).
6. Change the engine oil; refer to
Oil (page 31).
7. Charge the battery; refer to
36).
8. Check and adjust the track tension; refer to
the Track Tension (page
9. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
10. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
11. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place.
12. Cover the machine to protect it and keep it clean.
Servicing the Air
Greasing the Machine
Changing the Engine
Charging the Battery (page
Adjusting
39).
49