Pre-Maintenance Procedures; Using The Cylinder Lock; Accessing Internal Components - Toro 22342HA Operator's Manual

Pre-Maintenance
Procedures

Using the Cylinder Lock

WARNING
The loader arms may lower when in the raised
position, crushing anyone under them.
Install the cylinder lock(s) before performing
maintenance that requires raised loader arms.
Installing the Cylinder Lock
1. Remove the attachment.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the lynch pin securing the cylinder lock
to the loader arm
Figure 24
1. Cylinder lock
2. Lift cylinder
5. Lower the cylinder lock over the cylinder rod and
secure it with the lynch pin
6. Slowly lower the loader arms until the cylinder
lock contacts the cylinder body and rod end.
7. Secure the loader-valve lock; refer to
Loader-Valve Lock (page
(Figure 24).
3. Lynch pin
(Figure 24).
11).
Removing and Storing the
Cylinder Lock
Important:
Remove the cylinder lock from the rod
and fully secure it in the storage position before
operating the machine.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the lynch pin securing the cylinder lock.
5. Rotate the cylinder lock up to the loader arm
and secure it with the lynch pin.
6. Lower the loader arms.
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
g004182
26