Toro 22342HA Operator's Manual page 12

1. Loader arm/attachment-tilt
lever
Loader-Control-Reference Bar
The loader-control-reference bar helps stabilize your
hand while operating the loader arm/attachment-tilt
lever (Figure 4).
Auxiliary-Hydraulics Lever
•
To operate a hydraulic attachment in the forward
direction, rotate the auxiliary-hydraulics lever
rearward and pull it down to the reference bar
(Figure 12, number 1).
•
To operate a hydraulic attachment in the reverse
direction, rotate the auxiliary-hydraulics lever
rearward, then move it left into the upper slot
(Figure 12, number 2).
Note:
If you release the lever while in the F
position, the lever automatically returns to the
N position (Figure
EUTRAL
R position, it remains there until you pull it out
EVERSE
of the slot.
Figure 12
1. Forward-flow hydraulics
2. Reverse-flow hydraulics
Figure 11
2. Loader-valve lock
ORWARD
12, number 3). If it is in the
3. Neutral
Hour Meter/Tachometer
When the engine is off, the hour meter/tachometer
displays the number of hours of operation logged on
the machine. When the engine is running, it displays
the speed of the engine in revolutions per minute
(rpm).
After 50 hours and then every 100 hours thereafter
(i.e., 150, 250, 350, etc.) the screen displays CHG
OIL to remind you to change the engine oil.
g029981
After every 100 hours, the screen displays SVC
to remind you to perform the other maintenance
procedures based on a 100-, 200-, or 400-hour
schedule.
Note:
These reminders appear 3 hours prior to the
service interval time and flash at regular intervals for
6 hours.
Parking-Brake Lever
•
To engage the parking brake, push the lever
forward and to the left and then pull it rearward
(Figure 13).
Note:
The traction unit may roll slightly before the
brakes engage in the drive sprocket.
•
To release the brake, push the lever forward and
then right, into the notch
g004179
12
(Figure 13).
Figure 13
g005552